Differences between revisions 8 and 15 (spanning 7 versions)
⇤ ← Revision 8 as of 2013-05-28 09:09:40 →
Size: 1090
Editor: hgiger
Comment:
← Revision 15 as of 2020-09-04 13:23:44 → ⇥
Size: 1430
Editor: davidsch
Comment:
Deletions are marked like this. Additions are marked like this.
Line 1: Line 1:
#rev 2020-09-04 davidsch
Line 2: Line 4:

Please refer to the article below. For wireless it's the same procedure as for wired.
 Please refer to the lower section. For wireless it's the same procedure as for wired connections
Line 7: Line 7:
On OSX/ iOS you have to install a new profile to get all the authorization and security settings you need to connect
automatically to the network. Proceed as follows:
Line 8: Line 10:
On mac you have to install a new profile to get all the authorization and security settings you need to connect
automatically to the network. Proceed as followed:		  1. Via Browser choose website https://www.iphone.ethz.ch/
 1. Click 'Continue' and enter your ETH account credentials: {{{
As username use:
<username>@student-net.ethz.ch, if your are student at ETH
<username>@staff-net.ethz.ch, if your are a staff member of ETH
<username>@guest-net.ethz.ch, if your are a guest at ETH
Line 11: Line 17:
 1. Via Browser choose website 'www.iphone.ethz.ch'
 1. Click 'Continue' and enter your NETHZ credentials
 1. In section 'Available Configurations' choose '''for ETH Zurich'''		 As password, enter your ETH network password
}}}
 1. In section 'Available configurations' choose '''for ETH Zurich'''
Line 16: Line 22:
 1. Enter your NETHZ credentials again and click 'Install' (enter the admin password of your local machine).  1. Enter your ETH account credentials again and click 'Install' (enter the admin password of your local machine).
Line 20: Line 26:

----
[[CategoryNET]]

How to configure a wireless (WLAN) connection for 802.1x authorization

Please refer to the lower section. For wireless it's the same procedure as for wired connections

How to configure a wired connection for 802.1x authorization

On OSX/ iOS you have to install a new profile to get all the authorization and security settings you need to connect automatically to the network. Proceed as follows:

  1. Via Browser choose website https://www.iphone.ethz.ch/

  2. Click 'Continue' and enter your ETH account credentials: 

    As username use:
<username>@student-net.ethz.ch, if your are student at ETH
<username>@staff-net.ethz.ch, if your are a staff member of ETH
<username>@guest-net.ethz.ch, if your are a guest at ETH

As password, enter your ETH network password

  3. In section 'Available configurations' choose for ETH Zurich

  4. In section 'WLAN Setup' choose SSID eth

  5. Your Mac is now going to install the profile. In the upcoming window choose 'continue'.
  6. Enter your ETH account credentials again and click 'Install' (enter the admin password of your local machine).

Now the new profile has been installed. You can now see it in 'System Preferences'-> Networks. From there you can enable (or disable) the 802.1x functionallity by clicking 'Advanced'->'Tab:802.1x' and tick Enable automatic connection.

CategoryNET

Workstations/Network/Infrastructure/802.1xMacOS (last edited 2020-09-04 13:25:03 by davidsch)