Differences between revisions 10 and 18 (spanning 8 versions)
⇤ ← Revision 10 as of 2013-05-29 06:56:09 →
Size: 1122
Editor: hgiger
Comment:
← Revision 18 as of 2020-09-04 13:25:03 → ⇥
Size: 1452
Editor: davidsch
Comment:
Deletions are marked like this. Additions are marked like this.
Line 1: Line 1:
#rev 2020-09-04 davidsch
Line 2: Line 4:

Please refer to the article below. For wireless it's the same procedure as for wired.
 Please refer to the lower section. For wireless it's the same procedure as for wired connections.
Line 7: Line 7:
On OSX/ iOS you have to install a new profile to configure all the authorization and security settings you need to connect
automatically to the network. Proceed as follows:
Line 8: Line 10:
On mac you have to install a new profile to get all the authorization and security settings you need to connect
automatically to the network. Proceed as followed:		  1. In a web browser, navigate to the website https://www.iphone.ethz.ch/
 1. Click 'Continue' and enter your ETH account credentials: {{{
As username use:
<username>@student-net.ethz.ch, if your are student at ETH
<username>@staff-net.ethz.ch, if your are a staff member of ETH
<username>@guest-net.ethz.ch, if your are a guest at ETH
Line 11: Line 17:
 1. Via Browser choose website https://www.iphone.ethz.ch/
 1. Click 'Continue' and enter your NETHZ credentials
 1. In section 'Available Configurations' choose '''for ETH Zurich'''		 As password, enter your ETH network password
}}}
 1. In section 'Available configurations' choose '''for ETH Zurich'''
Line 16: Line 22:
 1. Enter your NETHZ credentials again and click 'Install' (enter the admin password of your local machine).  1. Enter your ETH account credentials again and click 'Install' (enter the admin password of your local machine).

How to configure a wireless (WLAN) connection for 802.1x authorization

Please refer to the lower section. For wireless it's the same procedure as for wired connections.

How to configure a wired connection for 802.1x authorization

On OSX/ iOS you have to install a new profile to configure all the authorization and security settings you need to connect automatically to the network. Proceed as follows:

  1. In a web browser, navigate to the website https://www.iphone.ethz.ch/

  2. Click 'Continue' and enter your ETH account credentials: 

    As username use:
<username>@student-net.ethz.ch, if your are student at ETH
<username>@staff-net.ethz.ch, if your are a staff member of ETH
<username>@guest-net.ethz.ch, if your are a guest at ETH

As password, enter your ETH network password

  3. In section 'Available configurations' choose for ETH Zurich

  4. In section 'WLAN Setup' choose SSID eth

  5. Your Mac is now going to install the profile. In the upcoming window choose 'continue'.
  6. Enter your ETH account credentials again and click 'Install' (enter the admin password of your local machine).

Now the new profile has been installed. You can now see it in 'System Preferences'-> Networks. From there you can enable (or disable) the 802.1x functionallity by clicking 'Advanced'->'Tab:802.1x' and tick Enable automatic connection.

CategoryNET

Workstations/Network/Infrastructure/802.1xMacOS (last edited 2020-09-04 13:25:03 by davidsch)