Differences between revisions 10 and 11
⇤ ← Revision 10 as of 2013-05-29 06:56:09 →
Size: 1122
Editor: hgiger
Comment:
← Revision 11 as of 2019-07-19 11:53:22 → ⇥
Size: 1388
Editor: davidsch
Comment:
Deletions are marked like this. Additions are marked like this.
Line 9: Line 9:
automatically to the network. Proceed as followed: automatically to the network. Proceed as follows:
Line 12: Line 12:
 1. Click 'Continue' and enter your NETHZ credentials  1. Click 'Continue' and enter your ETH account credentials: {{{
As "Username" use:
<username>@student-net.ethz.ch, if your are student at ETH
<username>@staff-net.ethz.ch, if your are a staff member of ETH
<username>@guest-net.ethz.ch, if your are a guest at ETH

As password, enter your ETH network password
}}}

How to configure a wireless (WLAN) connection for 802.1x authorization

Please refer to the article below. For wireless it's the same procedure as for wired.

How to configure a wired connection for 802.1x authorization

On mac you have to install a new profile to get all the authorization and security settings you need to connect automatically to the network. Proceed as follows:

  1. Via Browser choose website https://www.iphone.ethz.ch/

  2. Click 'Continue' and enter your ETH account credentials: 

    As "Username" use:
<username>@student-net.ethz.ch, if your are student at ETH
<username>@staff-net.ethz.ch, if your are a staff member of ETH
<username>@guest-net.ethz.ch, if your are a guest at ETH

As password, enter your ETH network password

  3. In section 'Available Configurations' choose for ETH Zurich

  4. In section 'WLAN Setup' choose SSID eth

  5. Your Mac is now going to install the profile. In the upcoming window choose 'continue'.
  6. Enter your NETHZ credentials again and click 'Install' (enter the admin password of your local machine).

Now the new profile has been installed. You can now see it in 'System Preferences'-> Networks. From there you can enable (or disable) the 802.1x functionallity by clicking 'Advanced'->'Tab:802.1x' and tick Enable automatic connection.

CategoryNET

Workstations/Network/Infrastructure/802.1xMacOS (last edited 2020-09-04 13:25:03 by davidsch)